AWT plant

- Dining room house 10, dismantling, 0.00, flat rate

- Turntable with suspension, stiffener, conductor rail and profile connection, 1.00, piece

- Single diverter as in/out diverter with suspension, stiffening, conductor rails and profile curve, 2.00, piece

- Lifting lowering table without conveyor element with drive 1 holding place L=approx. 1,450 mm for containers, 2.00, pieces

- Conveyor profile straight with suspension at least every 3m, stiffeners and conductor rails, 67.00, m

- Conveyor profile curve 90 degrees R = 750 mm with suspensions, stiffeners and conductor rails, 10,00, piece

- Conveyor profile curve up to 45 degrees R = 750 mm with suspensions, stiffeners and conductor rails, 2.00, piece

- Conveyor profile curve offset with suspensions, stiffeners and busbars, 0.00, piece

- Conveyor element with drive 1 holding place L=approx. 1,600 mm for containers (S/E stations), 10.00, pieces

- Conveyor element with drive 1 holding place L=approx. 1,400 mm for container storage, 58.00, piece

- Impact protection in front of conveyor element, 1 pair, 5.00 pair

- Transverse transfer carriage with conveyor element with drive 1 holding place L = approx. 1,700 mm for containers, 1.00, piece

- Conveyor element in the AWT elevator car with drive 1 holding place L=approx. 1,400 mm for containers, 2.00, pieces

- AWT fire protection closure as sliding gate for 2-track routing, 1.00, piece

- Barrier system with traffic light control (protective fence), 1.00, flat rate

- Steel construction, 1.00, flat rate

- Power supply completely in the control cabinet, 1.00, piece

- Area control S7-300, built in a fully equipped control cabinet, 2.00, piece

- Floor control AWT support point with control units completely in stainless steel column, 5.00, piece

- Control chassis accumulator, 1.00, flat rate

- Integration into the existing control system, 0.45, %

- Electrical installation complete, 0.45, %

- Software and programming, 0.45%, %

- Extension of emergency operation, 0.45, %

- Chassis, 3.00, piece

- Arrival report, 5,00, piece

- Height control mechanical, 5.00, piece

- Training and trial operation, 0.45%, %

- Specifications, 0.45, %

- Documentation according to EN, 0.45, %

- Lettering and signage, 0.45%, %

- decreases, 0.45, %

- Regieleistungen, 0,45, %

- FT elevator group, 2.00, pieces

- Documentation elevators according to EN, 1.00, psch

- Training elevators, 1.00, psch

- Acceptance of elevators, 1.00, pieces