Several existing buildings are currently located on the site of the so-called Kirchenwirt in the municipality of Wörthsee. The building of the former Kirchenwirt is to be preserved and renovated as a local building. The remaining existing buildings will be demolished and replaced by 2 new buildings with several residential units. In addition, an event hall and small commercial units are being built on the site.

In the course of the construction project, cast asphalt work must be carried out.

- approx. 590m2 floor area clean

- approx. 590m2 underground Vorb. Shot peening, gradient up to 5.2%

- approx. 1Psch subsoil. Grinding vertically and horizontally pump sump.

- approx. 6h. Examination of the adhesive strength.

- approx. 130m epoxy resin mortar throat, transition verticl/horizintal

- approx. 590m2 primer for APP polymer bitumen welding web, horizontal.

- ca. 590m2 APP Polymerbitumen-Schweißbahn, BE-PYP-PV 175 HL S4,5 bis 5,2% neig.

- approx. 27m lining of the gutter with the APP polymer bitumen welding web.

- approx. 125m polyurethane liquid plastic abd. vertical up to 700mm

- approx. 1 pt. polyurethane liquid plastic abd. vertical and horizontal, pump sump

- approx. 27m gutter elements made of polymer concrete.

- ca. 54 St. Rinnendeckroste.

- ca. 6,5m Dehnfugenprofile

- approx. 590m2 cast asphalt base layer, h= up to approx. 30mm, inclination up to 5.2%.

- approx. 590m2 cast asphalt wear layer, h= up to approx. 30mm, inclination up to 5.2%.

- remove approx. 590m2 sanding, cast asphalt screed.

- approx. 125m joint casting cold potting 2K, h= up to 35mm