Number of packages — 7:

— package number 1 — arthroscopic pump,

— Package 2 — shaver,

— package 3 — single-stage regeneration of articular cartilage,

— package number 4 — system for the reconstruction of the cruciate ligament,

— package number 5 — sewing meniscus kit,

— package number 6 — reconstruction of shoulder joint damage,

— Package No. 7 — Electrodes.

1. Delivery of drains to the arthroscopic pump used on the operating block of the Ordering Hospital (Stryker: Crossflow Integrated Arthroscopy Pump) or with the rental of the pump for the duration of the contract, item 100.

1. The shaver ends to the system present on the operating block of the Ordering Hospital (Stryker: Core Powered Driver Instrument) or with the insertion of the drive under the loan, pcs. 100.

1. Membrane — used for the treatment of cartilaginous and cartilaginous cavities, which is the basis for mesenchymal stem cells of human bone marrow based on hyaluronic acid technology.

Dimensions of the membrane 2x2 cm and 5x5 cm, thickness 2 mm, diameter of the fiber 10 microns, weight 120 g/m2, pcs. 10.

A system for the reconstruction of the anterior cruciate ligament provides the possibility of extracting graft from the semi-sinewal and slender muscle, as well as the ligament of the patella.

1. 8 hole plate made of rectangle-shaped titanium alloy with 12 mm rounded sides permanently connected to a thick graft protection loop, of UHMWP non-absorbable thread, allowing for suspension of graft in the femoral canal and from thread to drag the implant onto the outer cork. The double loop system for pulling up the graft must have the ability to reduce the length of the loop in the 90mm-10mm range with one hand. Implant pre-loaded onto carton, facilitating the installation of a transplant. Endobutton elongated 20mm constituting endobutton overlay for revision procedures, pcs. 50

2. Fastening of tibial part — titanium, sterile, cannilized interference screw available in diameter sizes of minimum 7 to 11 mm and minimum lengths between 20 and 40 mm, pcs. 50.

3. Nitinol wire 2 mm x 30 cm, leading to titanium screws, sterile 50 pcs.

4. Directional wires with mesh for dragging the graft through bone ducts, pcs. 6.

5. Directional wire 1.2 mm x 9”, for screws, pcs. 50

6. Canniulated drill with a diameter of 4.5 mm, pcs. 5

The Contracting Authority requires the delivery for the duration of the contract of the tools necessary for implantation of the above system and kit: a battery drill, including a charger and battery system, and a Jacobs type connector and a Kirschner wire guide.

Sterile meniscus sewing kit composed of 3-4 longitudinal implants made of PEEK material allowing you to wear 2 seams from one applicator. Applicators available in a 15-degree bend. The system stocked with a self-clamping node with controlled downpressure. Factory kit equipped with a disposable guide cannula attached to the applicator needle, protecting the implants from damage when inserting the applicator needle into the joint and used to measure the size of the damage.

Meniscus sewing kit — 3 implants — 40 pcs.

Meniscus sewing kit — 4 implants — 20 pcs.

1. Titanium anchor for reconstruction of the shoulder ring, self-tapping (screwed) with a diameter of 2.8 mm and 3.5 mm equipped with seam, non-absorbable, polyethylene, braided and disposable applicator, pcs. 10

2. Titanium anchor for reconstruction of rotator cone, self-tapping (screwed), 4.5mm, 5.0mm, 5.5mm or 6.5 mm diameter with elongated sharp end to facilitate implantation, with 2 or 3 threads (size 6,5 mm) non-absorbable, polyethylene, braided and disposable applicator pcs. 20.

3. Sterile, disposable, ready for use without any additional actions, a soft tissue piercing tool with a pre-loaded needle in the center, which, during application and passage through the rotator cone, curves upwards, pulling a thread or tape behind it, and the upper jaw captures them. Gun grip with trigger, no cyngle. Work shaft diameter 3.8 mm, working tip width 4.1 mm, working tip length 12.5 mm, working tip thickness 4.8 mm, optional for use with plastic cannula size 5.5 mm, pcs. 20.

4. Smooth surgical tape, which, compared to traditional surgical thread No 2, gives 75% more contact between the tendon and bone, while offering significantly lower levels of more evenly distributed pressure for bangeless procedures and

for procedures requiring knot tying. Sterile, packaged one at a time. Length 38” (95 cm) — pcs. 5

Polyethylene threads 38”, thickness # 2, of increased strength, sterile, packaged one at a time — 30 pcs.

Sterile disposable cannulas (10 pcs in the pack), rigid or flexible, having a full-length twist, fitted with a valve and having a thread support system, of sizes 4.5 mm to 8.5 mm (4.5; 5,5; 6.5; 7; 8; 8.5 mm) and lengths 45 to 90 mm (45; 55; 72; 90) — 30.

1. Electrodes for the calorizer /compatible with equipment on the equipment of the operating block — Smith&Nephew Werewolf coblation system, pcs. 75