Technical description:
5-axis milling machine with swivel rotary table for 5-axis simultaneous milling
- Tool changer with at least 30 magazine slots
- Tool holder SK40
- Internal coolant supply with at least 40 bar
- Emulsion mist extraction (alternatively preparation for extraction)
- Messtaster
- Heidenhain TNC 640 controller (In the Hereon technical center, only Heidenhain TNC 640 controllers are connected to the
Milling machines used in order not to jeopardize productivity due to various controls must be re-established
Machine with Heidenhain TNC 640 control system.)
- Speed at least 15000 1/min
- Verfahrwege:
X : approx. 500mm
Y: ca. 450mm
Z : approx. 400mm
- Integrated tool measurement
- Portable handwheel
- Additional blowing air on the headstock and flushing gun in the working room
Preamble
The Helmholtz-Zentrum hereon GmbH (Hereon) is a non-profit research institution and one of the 18 member institutions of the Hermann von Helmholtz Association of German Research Centres. 90% of the expenses of the Hereon are financed by the federal government (BMBF - Federal Ministry of Education and Research) and 10% by the four consortium states (Schleswig-Holstein, Hamburg, Lower Saxony and Brandenburg).
The statutory task of the society is to conduct research and development in a multidisciplinary network, especially in the fields of materials research, coastal, climate and environmental research as well as regenerative medicine.
Technical description:
5-axis milling machine with swivel rotary table for 5-axis simultaneous milling
- Tool changer with at least 30 magazine slots
- Tool holder SK40
- Internal coolant supply with at least 40 bar
- Emulsion mist extraction (alternatively preparation for extraction)
- Messtaster
- Heidenhain TNC 640 control (In the Hereon technical center, only Heidenhain TNC 640 controls are used on the milling machines, in order not to jeopardize productivity with various controls, another machine with Heidenhain TNC 640 control must be procured.)
- Speed at least 15000 1/min
- Verfahrwege:
X : approx. 500mm
Y: ca. 450mm
Z : approx. 400mm
- Integrated tool measurement
- Portable handwheel
- Additional blowing air on the headstock and flushing gun in the working area
Included: Training alternatively at the factory / at our site
delivery
Transport to the parking space (ground level)
startup
Warranty at least 24 months
After-sales service within 48 hours
Operating instructions 1x printed and 1x digital
Optional: Offer for a maintenance contract
The Helmholtz-Zentrum hereon has received further project funding at short notice.
For this reason, the Hereon needs another 5-axis milling machine that must have the same minimum technical requirements as the machine from the 2023/05-50742 award. For this reason, Hereon assumes a reduced deadline requirement and shortens the offer period.
Unfortunately, these funds are only available until the end of the year, so delivery and invoicing must be made by 23.12.2023.