The subject of the contract is the performance of the task entitled Modernization and reconstruction of the school building in Janowice, which includes. Part 1: Development of the area around the School Building in Janowice Part 2: Thermomodernization with reconstruction and extension of the School Building in Janowice Part 3: Purchase of a school bus with low-emission – hybrid drive

Part 1: Development of the area around the School Building in Janowice The subject of the contract is the preparation of purposeful multi-branch design documentation, along with obtaining legally required checks, arrangements, permits, etc., with the submission of an application for a building permit or notification to the competent administrative body, and the execution of construction works indicated in this documentation. The scope of works includes: - Installation of sanitary sewer made of PVC pipes laid at a depth of up to 3.0 m on a sand substrate, in an unfortified trench. Performing a leak test of the duct. Backfill of the trench with a manual layer of thick sand. 30 cm, then earth from the trench. Manual spreading of excess land. Connection - diameter 160 mm., - Discharge of rainwater from the parking lot with sand, oil and grease catchers; PVC pipes laid at a depth of up to 3.0 m, on a sand substrate, in an unfortified trench. Performing a leak test of the duct. Backfill of the trench with a manual layer of thick sand. 30 cm, then earth from the trench. Pipes with a diameter of 160mm., - External installation of rainwater cante made of PVC pipes with diameter. 110mm with inspection manholes with diam. 60mm - Lighting line on your own premises with 16 LED lamps with a height of 4m., - Pavements made of bet cubes. 6 cm thick, chamferless, on CEM ballast. - sand with a thickness of 5cm and sand. - Internal roads made of concrete blocks with a thickness.8cm on a foundation made of mineral aggregates and sand with curbs, - Parking lots made of concrete blocks with a thickness .8cm on a foundation of mineral aggregates and sand, - Green areas; lawn on humus substrate with a thickness of 10cm in a strip of 3m around the investment area, - Fence of the area; steel wire with diam. 4.2mm, system with a height of 1.5m with 1 wicket with a width of 1m, - Widening of the slope by 2m, sand / gravel compacted. The attached Functional and Utility Programme concerning Part 1 contains a broader scope than that covered by the present proceedings. The Contractor is obliged to evaluate and implement the scope specified in the bill of quantities: • LP. I. – Land development

Part 2: Thermomodernization with reconstruction and extension of the School Building in Janowice The subject of the contract is the preparation of purposeful multi-branch design documentation, along with obtaining legally required checks, arrangements, permits, etc., with the submission of an application for a building permit or notification to the competent administrative body, and the execution of construction works indicated in this documentation The scope of works includes: - Demolition of the external stairs of the arcade of the main entrance - Demolition of the pavement under plan. extension - Demolition of the surface paved with grit for the plan. parking and road, to depth 50cm - Dismantling windows with external and internal window sills and external doors - Dismantling trapezoidal sheet metal on the roof with wooden battens. - Dismantling of cast iron radiators in the school part 'A'. - Ramp for people npspr made of galvanized steel grating and concrete stairs covered with gres tiles with powder coated steel balustrade. - External stairs of the main entrance, concrete, covered with porcelain tiles with powder-coated steel balustrade. - Making a 30cm wide band around the building from stone pebbles on sand. - Extension with a sanitary part - foundations, load-bearing walls, reinforced concrete ceilings, wood. roof structure with metal tiles, external and internal finish. and technical infrastructure (turnkey). - Replacement of PVC windows and ALU exterior doors; 2-chamber (3-panes) - Installation of fire-smoke-tight doors for staircases - Preparation of external walls before insulation with mineral wool, breaking odp. plaster, cavity replenishment, alignment, etc. - Insulation of external walls with mineral wool 18cm thick with silicate plaster on a grid with 2x glue (system) - Insulation of the outer walls of the plinth and foundation with waterproof polystyrene foam 15cm thick on glue, bucket foil - Restoration of the corner buttresses of the building. - Restoration of the plinth of the building from stone tiles, on glue. - Repair of the roof truss; replacement of degraded elements, biol impregnation. and fire protection, new battens - Laying a new roof slope made of roof tiles with waterproofing. - Insulation of the ceiling above the first floor (attic) with mineral wool 30cm thick with a floor made of gypsum and fiber boards on joists. - Installation of roofing elements (downspouts, gutters and fittings). - Installation of lightning protection system. - Installation of external lighting on the building and antenna installations on the roof. - Installation of wall-mounted convector plate radiators in the school part 'A'. - Sanitary fittings, washbasins, toilet bowls, shower, urinals The attached Functional and Utility Programme for Part 2 contains a broader scope than that covered by the present proceedings. The Contractor is obliged to evaluate and implement the scope specified in the bill of quantities: • LP. II. – demolition and dismantling (with utilization) • LP III. – building • LP. IV. – building equipment

Part 3: Purchase of a low-emission hybrid school bus The subject of the contract is the purchase and delivery of a brand new low-emission school bus with hybrid drive and appropriate equipment, meeting the conditions and technical requirements set out in the law currently in force. 1) bus dimensions: - length up to 13.50 m - permissible total width of no more than 2.55 m (in accordance with the Regulation on technical conditions of vehicles), 2) number of places for transporting passengers: minimum 45 seats (it is allowed to offer four full-size folding or easily removable seats in the wheelchair space).