Working and protective equipment of different width classes W06-W12 approx. 4450m2

Height of the uppermost Geruestlage approx. 23.0 m

Roomed stiffening devices as length-oriented standing devices,

Breitenklasse W12, ca. 4300 m3,

top surface at approx. 23.0 m

Elevator, 2 pieces, elevator height up to 18.0 m

Load doors, 6 pieces, load class 3 - 5 (2,0-4,5 KN/m2)

Bracing doors for the length-oriented, spacious bracing device: 4 pieces, approx. 1120m3,

Other bracing and makeshift doors approx. 465 m3

Special equipment for furnishing the attic,

Roof pitch approx. 58 degrees, approx. 1100 m2

Internal brackets, projection up to 1.0 m, approx. 700 running meters

Geruest clothing with trapezoidal sheet metal as access protection,

Height up to 4.0 m, approx. 680 m2

Geruest clothing with trapezoidal sheet metal as wind and rain protection

Height over 16-25 m, approx. 800 m2

Equipment cladding with nets/tarpaulins approx. 800 m2

A load of 2 kN/m2 is sufficient for the working and safety equipment.

The anchoring subsoil usually consists of brick, quarry stone or mixed masonry.

The anchoring must be carried out with plastic duels at the highest possible location of the clay layers.

Up to a height of approx. 16.50 m, the rumble can be anchored to the façade.

From a height of 16.50 m above ground (from here the mansard roof begins) no anchoring is possible.

The stability is established by the spacious bracing device (length-oriented standing devices), width class W12.

The equipment must be carried out in such a way that the equipment of the working and safety equipment and the bracing planes of the support and bracing devices are carried out at the same height.

In some areas, the stiffening device is converted into a working and safety device.

The contractor shall submit a verifiable statics and execution drawings.