The subject of the contract is the operation of road lighting equipment in the city of Wałbrzych in the area of the housing estates: Piaskowa Góra, Podzamcze, Szczawienko and Lubiechów, in the amount of about 2,618 points.

The subject of the contract is the operation of road lighting equipment in the city of Wałbrzych in the area of the housing estates: Piaskowa Góra, Podzamcze, Szczawienko and Lubiechów, in the amount of approximately 2,618 points.

The Contractor will be obliged to provide all materials and necessary equipment to perform the subject of the contract.

The Contractor is required to have the necessary spare parts supply to eliminate faults in street lighting devices.

Materials from dismantling that are not suitable for re-use should be managed in accordance with the Waste Act (Journal of Laws 2013.21 as amended).

As part of the contract, the Contractor will be required to set up an emergency road lighting service 24 hours a day (for emergency cases).

The contractor selected by means of an open tender for the operation of road lighting equipment is responsible for the technical condition and safe functioning of all lighting equipment installed in this area and bears all the consequences of failure to meet the above requirements, including legal consequences in cases where improper operation creates a threat for human health and life or will cause an accident. (Does not apply to random events not due to the fault of the Contractor).

Detailed terms of the contract are included in the contract template and price form attached to the Specification of the Essential Terms of the Order.

Due to maintaining uniformity of lighting fittings on the streets and maintaining lighting parameters, it is advisable to use:

1. LED luminaires of the Ampera Mini type from Schreder and of the DigiStreet type from Philips or equivalent that meet the following parameters:

Requirements for LED fittings / equivalence conditions:

a) the luminaire should have a degree of protection against dust and water penetration not less than IP 66 and be equipped with a system regulating the pressure inside and outside the luminaire, which minimizes the phenomenon of steam condensation, resistance to atmospheric factors;

b) the body of the luminaire made of die-cast aluminum with very high impact resistance min. IK 08;

c) the lampshade should be made of flat, tempered glass (impact resistance min. IK 08);

d) if the luminaire is equipped with an external heat sink to dissipate heat emitted by LEDs, it is required that the design of the heat sink allows free drainage of water and dirt deposited on the luminaire;

e) the luminaire mounting mandrel should allow luminaire inclination adjustment;

f) elements fixing the luminaire on a pole, extension arm (screws, washers) should be made of stainless steel and guarantee stable installation;

g) the luminaire should be equipped with an LED panel equipped with LEDs emitting 4100K +/- 200K light color and a color rendering index of Ra min. 70;

h) the LED panel should be equipped with a terminal block, which in case of failure should allow its quick replacement. The LED panel should be an integral whole and not be separated into individual modules connected with solder connections;

i) the luminaire should be equipped with a group of lenses shaping road distribution. Each LED on the LED panel should have an individual optical element with the same characteristics, so that if one of the diodes burns out, only the luminous flux emitted by the luminaire should change, not the light distribution (uniformity of lighting should be maintained over the entire surface of the illuminated road);

j) the luminaire should be equipped with a power supply (controller) enabling in the future integration of the power reduction system and individual management of each luminaire's work and collecting information;

Due to the limited number of characters, the entire description of the contract is contained in Part III of the ToR.